Bay Technical Associates 5218H Manual De Usuario

NOTE: When changing the configuration of the host port, the
multiport will also respond with:

Change Device to NEW Configuration
Before Answering This Request.

CAUTION:  This message reminds you to change the serial port
configuration of the host device to match the new configuration of the
host port.  If they do not match, the multiport will be unable to interpret
the next command and you will be unable to access any multiport
function.  If this happens, cycle power on the multiport and
reconfigure the unit.  Make any necessary changes to host device
before answering the "Save Changes Permanently?" prompt.

The multiport will now return to the main configuration menu (see
Section 6.1).

By responding to the Enter Request: message at the end of the main
configuration menu (see 

Section 6.1) with "3" (Set Message

Terminate Character), you may set the message terminating
character for Modes of Operation 2, 3, 4 and 5.  The multiport will
respond with:

Current Terminate Character is.............0DH
Enter Terminate Character in Hex..........:

Enter the terminating character that you wish in the form of a two-digit
hexadecimal character (00 to 7F Hex).  For example, if you enter 0A
(Line Feed), the multiport will respond with:

Current Terminate Character is.............0AH
Save Changes Permanently? (Y/N):

If you answer "

Y" (yes), the new terminating character will be stored

permanently in non-volatile memory and the multiport will
subsequently power-up with the new terminating character in effect.  If
you answer "

N" (no), the new terminating character will be stored in

RAM and lost upon next power-up.  The multiport will now return to
the main configuration menu (see 

Section 6.1).