ZyXEL Communications nbg-418n Manual De Usuario
Chapter 20 Troubleshooting
NBG-418N User’s Guide
145
You will lose all of your changes when you push the RESET button.
To reset the NBG-418N,
1
Make sure the power LED is on.
2
Press the RESET button for longer than 1 second to restart/reboot the NBG-418N.
3
Press the RESET button for longer than five seconds to set the NBG-418N back to its factory-
default configurations.
default configurations.
If the NBG-418N restarts automatically, wait for the NBG-418N to finish restarting, and log in to the
Web Configurator. The username is admin and password is 1234.
Web Configurator. The username is admin and password is 1234.
If the NBG-418N does not restart automatically, disconnect and reconnect the NBG-418N’s power.
Then, follow the directions above again.
Then, follow the directions above again.
20.5 Wireless Problems
I cannot access the NBG-418N or ping any computer from the WLAN.
1
Make sure the wireless LAN is enabled on the NBG-418N.
2
Make sure the wireless adapter on the wireless station is working properly.
3
Make sure the wireless adapter installed on your computer is IEEE 802.11 compatible and supports
the same wireless standard as the NBG-418N.
the same wireless standard as the NBG-418N.
4
Make sure your computer (with a wireless adapter installed) is within the transmission range of the
NBG-418N.
NBG-418N.
5
Check that both the NBG-418N and your wireless station are using the same wireless and wireless
security settings.
security settings.
6
Make sure traffic between the WLAN and the LAN is not blocked by the firewall on the NBG-418N.
7
Make sure you allow the NBG-418N to be remotely accessed through the WLAN interface. Check
your remote management settings.
your remote management settings.
for more information.
I cannot access the Web Configurator after I switched to a non-router mode.