ZyXEL Communications 128L Manual De Usuario

• 

CHAP/PAP - Your Prestige will try CHAP when CHAP is 
requested by the Remote Node or PAP when PAP is 
requested by the Remote Node.   

• 

CHAP - Use CHAP only. 

• 

PAP - Use PAP only. 

8.  Route - This field determines the protocols that your Prestige will 

route. The choices for this field are determined by the features that 
are enabled. 

9.  Bridge - Bridging is used for protocols that are not supported or 

not turned on in the previous Route field, e.g., SNA. When bridging 
is enabled, your Prestige will forward any packet that it does not 
recognize to this Remote Node; otherwise, the unrecognized 
packets are discarded. The disadvantage of bridging is that it usually 
generates large amounts of traffic. Press the space bar to select 
either Yes or No. 

10. Edit PPP Options - To edit the PPP options for this Remote 

Node, move the cursor to this field, use the space bar to select Yes 
and press ENTER. This will bring you to Menu 11.2 - Remote 
Node PPP Options For more information on configuring PPP 
options, see the section Editing PPP Options. 

11. IP Addr - This is a required field if Route is set to IP. Enter the IP 

address of this Remote Node. 

12. Edit IP/IPX/Bridge Options  - To edit the parameters of the 

protocols, go to this field, select Yes and press ENTER. This will 
bring you to Menu 11.3 - Remote Node Network Layer Options. 
For more information on filling out this screen, refer to the chapter 
pertaining to your specific protocol. 

13. Session Option: Input Filter Sets and Output Filter Sets - In 

these fields, select which filter set(s) you would like to implement to 
filter the incoming and outgoing traffic between this Remote Node