Carrier Access Access Navigator Manual De Usuario
Access Navigator - Release 1.8
August 2003
8-7
Provision Access Navigator
Set Ethernet Properties
Set Ethernet Properties
NOTE:
Ethernet is required for Telnet, SNMP, and NetworkValet™ EMS. Ethernet
functions can only be provisioned through an RS-232 management session. If you are not
going to use the Ethernet port, do not make any connections to it.
going to use the Ethernet port, do not make any connections to it.
1. Show current Ethernet IP settings with the following command:
show ip
The following is a typical message:
IP Address and Mask:
192.168.0.233 255.255.255.0
IP Address of Gateway
192.168.0.250
NOTE:
IP Address – Each Access Navigator on the same Ethernet network must have
a unique static Internet Protocol (IP) address. IP addresses have the format
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
, where each xxx is a decimal number between 0 and 255. For
example, 192.168.0.123 is a valid IP address. Note that the address contains only three
periods, one between each of the four numbers. If the Ethernet interface is not used, type
none for the IP address.
periods, one between each of the four numbers. If the Ethernet interface is not used, type
none for the IP address.
NOTE:
Subnet Mask – The Access Navigator uses a subnet mask to identify the
permissible range of IP addresses on the local network. Large networks are usually
divided into smaller subnetworks, each with an assigned range of IP addresses.
Addresses outside the subnetwork will be directed to the Gateway address. Subnet masks
have the format xxx.xxx.xxx.xxx, where each xxx is a decimal number between 0 and
255. Subnet masks usually start with one or more groups of 255. Typical examples include
255.255.0.0
divided into smaller subnetworks, each with an assigned range of IP addresses.
Addresses outside the subnetwork will be directed to the Gateway address. Subnet masks
have the format xxx.xxx.xxx.xxx, where each xxx is a decimal number between 0 and
255. Subnet masks usually start with one or more groups of 255. Typical examples include
255.255.0.0
and 255.255.255.0. If a subnet mask is not used, type none or leave
blank.
NOTE:
Gateway Address – A gateway is any device that passes packets from one
network to another network in their trip across the Internet. Gateway addresses have the
same format as IP addresses. If a gateway address is not used, you must enter none for
the gateway address.
same format as IP addresses. If a gateway address is not used, you must enter none for
the gateway address.
NOTE:
MAC Address – The Ethernet media access control (MAC) address is fixed by
hardware and can not be changed. You can use the show ethernet command to display
the MAC address, a hexadecimal number such as 00-E0-97-AB-CD-EF, as well as the
Ethernet IP address and mask.
the MAC address, a hexadecimal number such as 00-E0-97-AB-CD-EF, as well as the
Ethernet IP address and mask.
2. If Ethernet settings are correct, skip remaining steps.