Carrier Access Access Navigator Manual De Usuario

provisioning GR-303 service. See also Provision DCS Service on 

2. If drop DS0 settings are correct, skip remaining steps.

GR-303 channels use robbed-bit signaling except when carrying ISDN BRI 

traffic.

3. Set DS0 type to "gr303" with the following command:

set ds0 <n:ch> type gr303

Example:

set ds0 13:1-16 type gr303

The Access Navigator/GR-303 supports GR-303 Direct Inward Dial (DID) circuit 

concentration on GR-303 interface groups to switches such as the Lucent 5ESS. 
(Two-way DOD/DID is not supported.) If the switch does not support GR-303 DID services, 
the DID circuits can be groomed to a DS1 going to a DID shelf in the Central Office. 

4. For GR-303 Direct Inward Dial (DID), set DS0 signal to "did" with the following command:

set ds0 <n:ch> signal did

Example:

set ds0 13:2 signal did

 P-Phone service requires a remote Adit 600 on the drop DS1 and a Nortel DMS 

switch on the switch DS1. The remote device management must be set to CAIP with the 
P-Phone option enabled.

5. For P-Phone service to a remote Adit 600, set DS0 to P-Phone with the following command:

set ds0 <n:ch> pphone

Example:

set ds0 13:3 pphone