Carrier Access Access Navigator Manual De Usuario
18-44
August 2003
Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Logon Remote
Purpose:
Starts a remote CLI management session with a Adit 600 TDM terminal connected to
a DS1 drop. During an RS-232 or Telnet CLI management session, the user enters the
logon
a DS1 drop. During an RS-232 or Telnet CLI management session, the user enters the
logon
remote command at the Access Navigator prompt. The remote terminal will
then respond with a Adit 600 prompt for entering Adit 600 CLI commands. For
descriptions of Adit 600 CLI commands, refer to the Adit 600 TDM User Manual.
descriptions of Adit 600 CLI commands, refer to the Adit 600 TDM User Manual.
NOTE:
To exit from a remote management session, see Exit Remote
Security:
Level 2 (operator)
Syntax:
logon remote <n>
Example:
logon remote 12
The following example is typical response to the logon remote command:
Access Navigator> logon remote 3
Remote CLI session attached on ds1 3.
(use <ctrl-c> to end remote CLI session.)
-----------------------------------------------------------
(use <ctrl-c> to end remote CLI session.)
-----------------------------------------------------------
CLI session with remote goes here.
Session ends when user presses <ctrl-c>.
Terminating remote 3 CLI session...
-----------------------------------------------------------
Remote CLI session on ds1 3 terminated.
-----------------------------------------------------------
Remote CLI session on ds1 3 terminated.
Access Navigator>
Switch TermID:DS0
Switch terminal identifier, 1 to 28, and DS0 channel, 1 to 24.
(TermID is not same as DS1 number.)
(TermID is not same as DS1 number.)
Drop DS1:DS0
Drop DS1 number, 1 to 32, and DS0 channel, 1 to 24.
CRV
Call Reference Value, 1 to 768
TMC Event
Message describing the event.
Cause
Numeric value assigned by switch to identify error type.
Field
Description
n
DS1 number, 1 to 32.
Item
Description