Carrier Access Access Navigator Manual De Usuario
18-84
August 2003
Access Navigator - Release 1.8
CLI Language Reference
CLI Command List
Figure 18-14. Remote RS-232 TSI Equipment Loopup
Security:
Level 2 (operator)
Syntax:
send remote <n> rs232 tsi <equipment|network> loopup
Example:
send remote 9 rs232 tsi equipment loopup
Example:
send remote 9 rs232 tsi network loopup
Message:
Loop command sent to remote.
Send Remote SDSL Payload Loopup
NOTE:
This command applies only to a remote Access Bank II connected
to the Access Navigator by a DS1 using Carrier Access FDL management
protocol. For normal operation, the loopback must be disabled by the send
remote
protocol. For normal operation, the loopback must be disabled by the send
remote
loopdown command.
NOTE:
Only one port of the Access Bank II can be looped up at a time. If a
loopup command is received for a second port, the first port will be looped down
automatically before the second port is looped up.
automatically before the second port is looped up.
NOTE:
To check remote loopback status, use the read remote loopback
command. See Read Remote Loopback on
Purpose:
Sends an out-of-band (FDL) message to a remote Access Bank II over the Access
Navigator DS1. It is used to verify SDSL signal processing.
Navigator DS1. It is used to verify SDSL signal processing.
Field
Description
n
DS1 number, 1 to 32.
equipment
Loopup the equipment side
network
Loopup the network side
RS-232
TSI Equipment Loopup
RS-232
DS1
Access
Navigator
CA FDL
Command
Access Bank II
T1
Interface
Time Slot
Interchange
Framer