Carrier Access 1750 Manual De Usuario

Alarms are sent to the control console and the system log. LEDs display alarm 
conditions. Additionally, the Broadmore 1750 has an alarm port on the chassis rear for 
connection to the user’s

 

remote indicators. The alarm port is a four-wire terminal block 

providing form “C” relay contact closure signals. Two wires are labeled “Major” (in 
and out) and two are labeled “Minor” (in and out) as shown below. The alarm connector 
on the lower back of the chassis is shown below. The connector is a compression type 
in which the wire is inserted in the lower opening and the compression screw above is 
tightened to secure the wire. A small flathead screwdriver is required to secure the 
wires. 

1. Run the alarm cables to the connection point on the chassis rear as shown 

above.

2. Insert the cable wires and tighten the compression screws to secure the wires.