Carrier Access none Manual De Usuario
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
20-7
Configuration - VLAN Mode
tag-all
Use the VLAN tag-all command to enable dot1q tagging for all ports.
If VLAN tagging is enabled on all ports, an ingress port should forward any untagged or priority tagged
frames with a VID equal to the ingress port’s PVID and set the priority of the untagged frame to that of
the ingress port. The priority of the tagged frame remain unchanged. See the port-priority command, on
page 20-5, to set the priority of the port.
Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a port
forwarding frames to another port(s) in the switch.
If VLAN tagging is enabled on all ports, an ingress port should forward any untagged or priority tagged
frames with a VID equal to the ingress port’s PVID and set the priority of the untagged frame to that of
the ingress port. The priority of the tagged frame remain unchanged. See the port-priority command, on
page 20-5, to set the priority of the port.
Note: Ingress port is a port receiving frames from a source external to the switch. Egress port is a port
forwarding frames to another port(s) in the switch.
Syntax:
(config-vlan)# tag-all {disable|enable}
Example:
(config-vlan)# tag-all enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
vlan-feature
Use the VLAN mode vlan-feature command to enable/disable the VLAN feature on the device.
Note: This command is not visible on the Adit 3500 or MSR, as VLAN is always enabled on these
products.
Note: This command is not visible on the Adit 3500 or MSR, as VLAN is always enabled on these
products.
Syntax:
(config-vlan)# vlan-feature {disable|enable}
Example:
(config-vlan)# vlan-feature enable
Supported Platforms:
Adit 3104, Adit 3200
Field
Definition
disable
Disable dot1q for all ports. Default.
enable
Enable dot1q for all ports.
Field
Definition
disable
Disable VLAN feature.
enable
Enable VLAN feature.