Carrier Access Terminal Server Router Manual De Usuario

Installation of the router card into the Adit chassis.

l

Unit can be on or off

l

Router card will work in any slot

l

Slide card into slot until fully seated

l

Router has completed it’s boot cycle when CRD light is solid

Configuration can be done with the following CLI commands or 

with the Router Menu-Driven Software.

set {ds0-addr} type data

Confirm DS0 is set to type data. 
ds0-addr = {slot:port:channel} of DS0
Example: set a:1:1-24 type data

connect {slot:port:trunk} 

{slot:port:channel}

Cross-connect T1 to router card.
Example: connect a:1:1-24 6:1:1 (router in slot 6)

set {router-addr} proxy

Disable/enable router proxy. 
router-addr = {slot:port}| of router card. 
Example: set 6:1 disable.

set {slot:port} up

Set Router LAN as In-Service. 
Example: set 6:1 up

telnet {router_card-addr}

Telnet to Router card.
router_card-addr = {slot} location of router card
Example: telnet 6 (if earlier than 3.0 release {slot:port} 
must be used)

Local and Remote Profile Setup

 

reinitialize

To enable any configuration changes, the card must be 
reinitialized.