Paradyne 8747 Manual De Usuario
4-1
8700-A2-GB20-00
April 2000
Cross-Connecting Ports
4
Overview
Configuration of the cross-connections consists of the following steps:
-
Determine how the ports will be connected and configured.
-
On the Network Interface Options screen, enable if necessary the DSL ports
that will be in the cross-connection. The ports are enabled by default.
that will be in the cross-connection. The ports are enabled by default.
-
On the DSX-1 or G.703 Interface Options screen, enable the DSX-1 or
G.703 ports that will be in the cross-connection. For G.703, specify whether
Time Slot 16 is used for signaling (voice mode).
G.703 ports that will be in the cross-connection. For G.703, specify whether
Time Slot 16 is used for signaling (voice mode).
-
On the System Clock screen, configure the system clock.
-
On the Cross-Connect Mode screen:
— Define all DS1 Bypass ports
— Define all DS1 Cross-Connect ports
— Define all DS0 Cross-Connect ports
-
On the Assign Time Slots screen, configure the DS0 cross-connections.
This chapter describes the use of the Cross-Connect Mode and Assign Time
Slots screens. See Appendix A,
Slots screens. See Appendix A,
Examples in this chapter show screens for DSX-1 models. The principles of
cross-connection are the same for G.703.
cross-connection are the same for G.703.
IMPORTANT:
All DSL time slots are available for cross-connect regardless of DSL
line rate, but all time slots are available for data transport only if the
DSL line rate is the full rate (1552 for DSX-1 or 2064 for G.703).
Configure only the time slots intended for use.
line rate, but all time slots are available for data transport only if the
DSL line rate is the full rate (1552 for DSX-1 or 2064 for G.703).
Configure only the time slots intended for use.