Black Box LR0202A-KIT Manual De Usuario
724-746-5500 | blackbox.com
Page 12
G.SHDSL Four-Wire Ethernet Network Extender Kit
4. Console Configuration
The LR0202A-KIT provides an RS-232C console port for user to monitor the OA&M status through a VT100 terminal. This section
covers the operating procedures and settings for all screen selections.
covers the operating procedures and settings for all screen selections.
Connect the RS-232 cable to the computer’s COM port as shown in Figure 4-1. Set the personal computer to VT100 or VT102
type through HyperTerminal. Press the <ESCAPE> key and the main menu will be shown on the terminal’s screen. The terminal
operations can then start.
type through HyperTerminal. Press the <ESCAPE> key and the main menu will be shown on the terminal’s screen. The terminal
operations can then start.
If you press the <ESCAPE> key and the screen of the terminal does not display, the COM port might be set incorrectly. Choose
the correct COM port (COM1 or COM2) on the computer, and press the <ESCAPE> key again to make sure that the main menu
appears on the terminal screen.
the correct COM port (COM1 or COM2) on the computer, and press the <ESCAPE> key again to make sure that the main menu
appears on the terminal screen.
NOTE: Set the COM port should be set as 9600 bps, 8 data bits, 1 stop bit, no parity, and no flow control.
Figure 4-1. Connection for console port with RS-232 terminal.
RS-232 Cable
VT100/102 Terminal
PC COM Port
Baud rate: 9600
Data bits: 8
Stop bits: 1
Parity: no
Flow control: none
Data bits: 8
Stop bits: 1
Parity: no
Flow control: none