Black Box EncrypTight Enforcement Point (ETEP) Manual De Usuario

Installing the ET1000A

ETEP Installation Guide

41

The steps to perform for a typical installation are listed below.

 outlines the standard cables used with each port on the ET1000A. The connector type listed 

indicates only what is required to connect to the ET1000A port, and may or may not be the same 
connector type required for the other end of the cable. Some cables are supplied by Black Box and others 
are user-supplied.

1

Review the cabling requirements.

1

Unpack the shipping package.

2

Prepare a space for installation of the ET1000A.

3

Connect the cables.

4

Apply power to the ET1000A.

Power receptacles

Power supply cables certified 

and approved for use in the 

country of interest

Black Box

RS-232 Port

Shielded copper null modem 

cable, RS-232 DB9 connector 

(female to male)

Black Box

Ethernet Management Port 

(RJ-45)

Shielded Category 5 straight 

through cable (STP), RJ-45 

connector

a

a. The 10/100 Ethernet management port is auto-sensing for polarity. You can use a shielded Category 5 straight 

through cable or a shielded crossover cable when connecting to this port.

Black Box

Ethernet Management port 

(SFP)

Not applicable. Port is not 

enabled in this release.

Not applicable

Local and Remote Gigabit 

Ethernet ports
• Optical SFP transceivers

• 1000Base-LX SFPs

9/125

m single-mode duplex 

fiber or simplex fiber pair (1 

transmit, 1 receive), 1310 nm 

nominal wavelength, LC 

connector

OR
• 1000Base-SX SFPs 

62.5/125

m multi-mode 

duplex fiber or simplex fiber 

pair (1 transmit, 1 receive), 

850nm nominal wavelength, 

LC connector

Available as accessory options

Local and Remote Gigabit 

Ethernet ports
• Copper SFP transceivers

Shielded Category 5 straight 

through cable (STP), RJ-45 

connector

Available as accessory options

Aux1 port (SFP)

Not applicable. Port is not 

enabled in this release.

Not applicable