Cisco Systems 11000 Series Manual De Usuario
Chapter 2 Cabling the CSS
Powering Up the CSS
2-34
Cisco 11000 Series Content Services Switch Hardware Installation Guide
78-15146-02
Powering Up the CSS
To power up the AC on a CSS 11050, CSS 11150, or CSS 11800:
1.
Attach the power cord to the CSS 11050 or CSS 11150 rear panel AC
connector, or to the CSS 11800 AC connector (see the
connector, or to the CSS 11800 AC connector (see the
section earlier in this chapter).
2.
Power on the CSS by toggling the power switch to the 1 (on) position.
For DC power on a CSS 11150 or CSS 11800, set the external disconnect device
to the 1 (on) position.
to the 1 (on) position.
For information concerning the boot process on an 11000 series CSS, refer to the
Content Services Switch Administration Guide. For general hardware
troubleshooting information, see the following section.
Content Services Switch Administration Guide. For general hardware
troubleshooting information, see the following section.
Powering Down the CSS
To shutdown a CSS gracefully and avoid introducing lost or fragmented files,
always use the shutdown command prior to removing power from the CSS. This
command is available in boot mode.
always use the shutdown command prior to removing power from the CSS. This
command is available in boot mode.
For example:
(config-boot)# shutdown
Once the CSS shuts down all processes, you may remove power from the CSS.
Troubleshooting CSS Hardware Components
This section provides general troubleshooting information for the CSS
components. It includes the following sections:
components. It includes the following sections:
•
•
•