Cisco Systems 611 Manual De Usuario
Chapter 3 Installing the Cisco Wide Area Application Engine
Tools and Parts Required
3-2
Cisco Wide Area Application Engine 511 and 611 Hardware Installation Guide
OL-7220-02
Tools and Parts Required
A sliding rail rack-mount kit and cable management assembly is included in your
shipping container accessory box. The rack-mount kit is suitable for mounting the
device in a 19-inch (48.26-cm) four-post equipment rack.
shipping container accessory box. The rack-mount kit is suitable for mounting the
device in a 19-inch (48.26-cm) four-post equipment rack.
Angle brackets for mounting the device in a two-post rack are also included in
your shipping container.
your shipping container.
You need the following parts and tools to install the device in a rack:
•
Flat-blade screwdriver
•
Phillips screwdriver
•
One rack-mount kit
•
Documentation
Installing the Cisco Wide Area Application Engine
Place the device in the desired location. You can mount it in a rack for your
convenience, or place it on a solid, stable surface. If you do not plan to install the
unit in an equipment rack, proceed to the
convenience, or place it on a solid, stable surface. If you do not plan to install the
unit in an equipment rack, proceed to the
Racks are marked in vertical increments of 1.75 inches (4.44 cm). Each increment
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.
is referred to as a rack unit (RU). A 1-RU device is 1.75 inches (4.44 cm) tall.