Cisco Systems 511 Manual De Usuario
1-13
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Chapter 1 Introducing the Content Engine
Hardware Features
Ethernet Port
The Content Engine comes with one integrated dual-port Ethernet controller. This
controller provides an interface for connecting to 10-Mbps, 100-Mbps, or
1000-Mbps networks and provides full-duplex (FDX) capability, which enables
simultaneous transmission and reception of data on the Ethernet LAN.
controller provides an interface for connecting to 10-Mbps, 100-Mbps, or
1000-Mbps networks and provides full-duplex (FDX) capability, which enables
simultaneous transmission and reception of data on the Ethernet LAN.
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the device.
(UTP) cable to the RJ-45 connector on the back of the device.
Note
The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in
the network be Category 5 or higher.
the network be Category 5 or higher.
Ethernet Port Connector
shows the pin number assignments for the Ethernet RJ-45 port.
Figure 1-10
Ethernet Port Connector
Serial Port
The Content Engine has one standard serial port connector located on the back of
the device.
the device.
Serial Port Connector
shows the pin number assignments for the 9-pin, male D-shell serial
port connector on the back of the device. These pin number assignments conform
to the industry standard.
to the industry standard.
1
8
Link LED
(green)
Activity LED
(green)
83195