Canon LV-WX300USTI Manual De Usuario

— ii— 

  Place the projector in a horizontal position 

The tilt angle of the projector should not exceed 15 degrees, nor should the projector be 
installed in any way other than the desktop and ceiling mount, otherwise lamp life could decrease 
dramatically, and may lead to other unpredictable damages. 
 

  Allow at least 50 cm clearance around the exhaust vent. 

 

  Ensure that the intake vents do not recycle hot air from the exhaust vent. 
  When operating the projector in an enclosed space, ensure that the surrounding air temperature 

within the enclosure does not exceed operation temperature while the projector is running, and the 
air intake and exhaust vents are unobstructed. 

  Turn on Altitude Mode when located in high altitude areas 
  The projector can only be installed upright or inverted.  
  When installation the bracket, make sure the weight limit is not exceed and firmly secured. 
  Avoid installing at high temperature, insufficient cooling and heavy dust locations. 
  Keep your product away from fluorescent lamps to avoid malfunction caused by IR interference. 
  The VGA IN connector should be connected to the VGA IN port. Note that it should be inserted 

tightly, with the screws on both sides securely fastened to ensure proper connection of the signal 
wire for achieving optimal display effect. 

  The AUDIO IN connector should be connected to the AUDIO IN port and CANNOT be connected 

to AUDIO OUT or other ports like BNC, RCA; otherwise, it will lead to mute output and even 
DAMAGE the port. 

  The power cord and signal cable should be connected before power on the projector. During the 

projector starting and operating process, DO NOT insert or remove the signal cable or the power 
cord to avoid damaging the projector. 

  Make sure the air outlet is 50cm clear of any obstruction to ensure proper cooling. 
  Air outlet location should not be in front of the lens of other projector to avoid causing illusions. 
  Keep the outlet at least 100cm away from the inlets of other projectors 
  The projector generates a massive amount of heat during use. The internal fan dissipates the heat 

of the projector when shutting down, and such process may continue for a certain period. After the 
project enters STANDBY MODE status, press the AC power button to turn off the projector and 
remove the power cord. DO NOT remove the power cord during the shutdown process, as it may 
cause damage to the projector. In the meantime, the delayed heat radiating will also affect the 
service life of the projector. The shutdown process may vary depending on the model used. 
Whatever the case may be, be sure to disconnect the power cord till after the projector enters the 
STANDBY status. 

  Make sure there is no object blocking air input within 30 cm. 
  Keep the inlet away from other heat sources 
  Avoided heavy dust area