Sanyo HF15000L Manual De Usuario

Check the LAMP 1/2/3/4 REPLACE indicators on top 

of the projector. When any of the indicators blinks 

rapidly, wait at least 20 minutes until it blinks slowly. 

After that, go to the next step. When any of the 

indicators blinks slowly, go to the next step. 

Loosen the two screws that securing the lamp and 

pull out the lamp by using the handle. (See the right 

lower figure.)

Loosen the screw on the lamp cover. Open the lamp 

cover. (See the right upper figure.)

Replace the lamp with a new one and tighten the 

two screws. Make sure the lamp is set properly.

Follow these steps to replace the lamp.

Close the lamp cover and tighten the screw. 

SCREW

LAMP COVER

LAMP 2

LAMP 1

-  For continued safety, replace with a lamp assembly 

of the same type. 

-  Do not drop the lamp assembly or touch a glass 

bulb! The glass can shatter and may cause injury.

-  When  replacing  the  lamp,  do  it  within  30  minutes  after 

opening the lamp cover. 

-  Do not insert hand in the empty lamp compartment after 

the lamp is removed.

Allow the projector to cool for at least 20 minutes 

before you open the lamp cover. The temperature 

inside the projector becomes very hot.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the 

screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one after it has cooled down. 

The timing when the LAMP REPLACE indicator lights up is depending on the mode that you specified for the Lamp 

control function.

LAMP 3

HANDLE

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken.

If replacing a lamp of the projector which has been installed on the ceiling, you should always assume that the 

lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover 

gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or 

mouth, seek medical advice immediately.

LAMP 4

SCREW

SCREW

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER.