Samsung BP59-00092H-05 Manual De Usuario
1-3
Major Safety Precautions
Caution
If the product generates a strange noise, a
burning smell, or smoke, unplug the power
plug immediately and contact a service
center.
burning smell, or smoke, unplug the power
plug immediately and contact a service
center.
•
Failing to do so may result in electric
shock or fire.
shock or fire.
If water or a foreign substance enters the
product, turn the product off, unplug the
power cord from a wall outlet, and contact
a Service Center.
product, turn the product off, unplug the
power cord from a wall outlet, and contact
a Service Center.
If the power plug pin or jack is exposed to
dust, water or alien substances, clean it
thoroughly.
dust, water or alien substances, clean it
thoroughly.
•
There is a danger of electric shock or
fire.
fire.
Do not use the product while it indicates a
malfunction, such as no sound or no pic-
ture.
malfunction, such as no sound or no pic-
ture.
•
Turn the product off immediately,
unplug the power cord from a wall
outlet, and contact a Service Center.
unplug the power cord from a wall
outlet, and contact a Service Center.
When cleaning the product, disconnect the
power cord and clean the product with a
soft dry cloth.
power cord and clean the product with a
soft dry cloth.
•
Avoid using chemicals such as wax,
benzene, alcohol, thinner, mosquito-
repellent, fragrance, lubrication or
cleansing agent when cleaning the
product.
benzene, alcohol, thinner, mosquito-
repellent, fragrance, lubrication or
cleansing agent when cleaning the
product.
This may result in the exterior being
deformed or the print being removed.
deformed or the print being removed.
When a gas leak occurs, do not touch the
product or the power plug and ventilate
immediately.
product or the power plug and ventilate
immediately.
•
A spark may result in an explosion or
fire.
fire.
•
During a thunder or lighting storm, do
not touch the power cord or antenna
cable
not touch the power cord or antenna
cable
When not using the product for a long
time, such as leaving your home, unplug
the power cord from the wall outlet.
time, such as leaving your home, unplug
the power cord from the wall outlet.
•
Otherwise, it may cause dust
accumulation and result in fire caused
by overheating or a short circuit or
result in an electric shock.
accumulation and result in fire caused
by overheating or a short circuit or
result in an electric shock.
Do not touch the lens on the product.
•
This may cause damage to the lens.
If the product is installed in a location
where the operating conditions vary con-
siderably, a serious quality problem may
occur due to the surrounding environment.
In this case, install the product only after
consulting our Call Center.
where the operating conditions vary con-
siderably, a serious quality problem may
occur due to the surrounding environment.
In this case, install the product only after
consulting our Call Center.
•
Places exposed to microscopic dust,
chemicals, too high or low temperature,
high humidity, such as airports or
stations where the product is
continuously used for a long time
chemicals, too high or low temperature,
high humidity, such as airports or
stations where the product is
continuously used for a long time
etc..
Do not touch any outer part of the product
with tools such as a knife or a hammer.
with tools such as a knife or a hammer.
If you drop the product or the case is dam-
aged, turn the power off and unplug the
power cord. Contact a service center.
aged, turn the power off and unplug the
power cord. Contact a service center.
•
Failing to do so may result in fire or
electric shock.
electric shock.
To clean dirt or stains on the front projec-
tion lens, use spray or a wet cloth damp-
ened with neutral detergent and water.
tion lens, use spray or a wet cloth damp-
ened with neutral detergent and water.
Make sure to place your remote control on
a table or desk.
a table or desk.
•
If you step on the remote control, you
may fall and hurt yourself or the
product may be damaged.
may fall and hurt yourself or the
product may be damaged.
Ask a Service Center to clean the
interior
of the projector at least once per year.