Toshiba TDP-TW95 Manual De Usuario

81

80

1

2

Loosen the three lamp locking screws, pull up the
handle, and remove the lamp.

Align the orientation, press down the new lamp
until the bottom is reached, and lock in place using
the three lamp locking screws.

Align the cover, and press it in, then tighten the
screws loosened in step 

 until the lamp cover is

no longer loose.

See the lamp’s manual for instructions on resetting
the lamp timer.

• The Lamp time item in the Status display menu indicates the time of lamp use (as a

rough guide). 

• It is recommended that the lamp be replaced after 2,000 hours of use. When [Lamp time]

reaches 2,000 hours, the 

 icon and a message will appear. (After 2,000 hours, they will

appear when the power is on at the first time every 100 hours.) This display disappears
when you press the 

 button.

• Attach the lamp cover correctly so that it is not loose. If it is not attached correctly, the

projector may fail to be powered on or the lamp may fail to come on.

• Always replace the lamp with a new one.
• The lamp is made out of glass. Do not touch the glass surface with your bare hands,

bang it, or scratch it. (Dirt, jolts, scratches and the like could break the lamp.)

This projector’s lamps contain trace amounts of environmentally harmful inorganic
mercury. Be careful not to break used lamps, and dispose of them in accordance with
local regulations.

2

1

Wait for at least 1 hour.

Loosen the two screws, raise the lamp cover
with your fingers as shown to remove the lamp
cover. Use care to avoid any damage to nails
and/or tip of your finger(s). If you have any
difficulty in removal, you can use a screwdriver
or any other smaller tool for your convenience.

Lamp cover

2

1

A lamp is consumable supplies. If used for extended periods, images will appear dark, and
the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime
of the lamp depends on condition of use.) If this happens, replace it with a new one.

• If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealer-

ship when the lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger
of damage from falling pieces of glass if the lamp is broken. Besides, working at high
elevations can also be hazardous. Do not attempt to replace the lamp by yourself.

• When replacement is required, be sure to use:

TLPLW9 for TDP-TW95 or
TLPLW10 for TDP-TW100
(sold separately).

• If you have been using the projector, the lamp will be very hot, and may cause burn injuries.

Wait for the lamp to cool (for longer than 1 hour) before replacing it.

• If the lamp should break, please handle with care to avoid injury due to broken pieces and

contact your dealer for repair service.