Viewsonic PJ700 Manual De Usuario

ViewSonic  PJ700

Lamp Unit
• To order a new lamp unit contact ViewSonic Customer Support.
• Estimated lamp life is 1500 hours.

Make sure the power cord is disconnected and the unit 

is cool. Wait 45 minutes for the lamp to cool down.

Gently turn the projector over and place it on a towel or blanket. 
Expose the lamp cover on the bottom of projector.

Loosen the lamp cover screw as shown.

Gently remove the cover.

Loosen the lamp unit screws (after the cover is removed).

Gently pull the unit out of the lamp compartment using the flip-
up handle grip.

Gently insert the new lamp.

Replace the lamp unit screws.

Replace the cover and secure with the lamp cover screw.

Resetting the Lamp Timer
After replacing the lamp, the lamp LED lights a steady red and the 
“Change the Lamp” message displays. 

Within 10 minutes after turning on the power do the following:

Press (and hold for three seconds) the Reset button on the 
projector control pad. The “Lamp hours” message displays on the 
bottom of the screen.

Press the Reset button on the projector control pad while the 
lamp timer is displayed. 

Use the direction arrows to select zero (0) and wait until the 
Lamp timer display clears.

Important: The message functions will not operate properly if the 
lamp timer is reset without replacing the lamp or if the lamp timer is 
not reset when the lamp is replaced.