Viewsonic VS13835 Manual De Usuario

ViewSonic

Pro9500

Maintenance

Replacing the internal clock battery

This projector has internal clock that uses a battery. When

the clock of the network function does not work correctly,

please try solution by replacement of the battery:

HITACHI

MAXELL, part number CR2032 or CR2032H.

OPEN

OPEN CLOSE

Raised dot

Battery

Knob

Battery

Cover

Turn the projector off, and unplug the power cord. Allow

the projector to cool sufficiently.

After making sure that the projector has cooled

adequately, slowly turn over the projector, so that the

bottom is facing.

There is a raised dot near the battery cover at the

bottom of the projector. Turn the cover in the direction

indicated

OPEN to position one end of the slit on the

cover with the dot, using a coin or the like. And then

pick the cover up to remove it.

Pry up the battery using a flathead screwdriver or the

like to take it out. While prying it up, put a finger lightly

on the battery since it may pop out of the holder.

Replace with a new battery of the specified type. With

the plus side facing up, slide the battery under the claw

of the spring fitting. And press down on the battery until

it snaps into place.

Replace the battery cover in place, then turn it in the

direction indicated

CLOSE to position the knob of the

cover with the dot on the bottom case to fix the cover,

using a coin or the like.

NOTE

• The internal clock will be initialized by removing the battery. For

setting the clock, see the

Network Guide.

►Be careful of handling a battery, as a battery can cause explosion,

cracking or leakage, which could result in a fire, an injury, and environment pollution.

• Use only the specified and perfect battery. Do not use a battery with damage,

such as a scratch, a dent, rust or leakage.

• When replacing the battery, replace it with a new battery.

• When a battery leaked, wipe the leakage out well with a waste cloth. If the leakage

adhered to your body, immediately rinse it well with water. When a battery leaked in

the battery holder, replace the batteries after wiping the leakage out.

• Make sure the plus and minus terminals are correctly aligned when loading a battery.

• Do not work on a battery; for example recharging or soldering.

• Keep a battery in a dark, cool and dry place. Never expose a battery to a fire or water.

• Keep a battery away from children and pets. Be careful for them not to swallow a

battery. If swallowed consult a physician immediately for emergency treatment.

• Obey the local laws on disposing a battery.

WARNING