Viewsonic VS11959 Manual De Usuario
ViewSonic 23 PJ513D/PJ513DB
Setting the User 1/User 2 mode
There are two user-definable modes if the current available preset modes are not
suitable for your need. You can use one of the preset modes (except the User 1/2) as a
starting point and customize the settings.
suitable for your need. You can use one of the preset modes (except the User 1/2) as a
starting point and customize the settings.
1.
Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2.
Go to the PICTURE > Preset Mode menu.
3.
Press
/
to select User 1 or User 2 Mode.
4.
Press
to highlight Reference Mode.
This function is only available when User 1, or User 2 mode is selected up in the Preset Mode
sub-menu item.
sub-menu item.
5.
Press
/
to select an preset mode that is closest to your need.
6.
Press
to select a menu item to be changed and adjust the value with
/
. See
below for details.
7.
When all settings have been done, highlight Save Settings and press MODE/ENTER
to store a set of settings for User 1 or User 2.
to store a set of settings for User 1 or User 2.
8.
The confirmation message 'Setting Saved' displays.
All saved setting values in User 1 or User 2 mode can be seen when you open the
OSD menu again, select User 1 or User 2 in the Preset Mode sub-menu item, one
setting value could save into User 1 or User 2 memory only.
OSD menu again, select User 1 or User 2 in the Preset Mode sub-menu item, one
setting value could save into User 1 or User 2 memory only.
Fine-tuning the image quality in user modes
According to the detected signal type, there are some user-definable functions
available when User 1 or User 2 mode is selected. You can make adjustments to these
functions based on your needs.
available when User 1 or User 2 mode is selected. You can make adjustments to these
functions based on your needs.
Adjusting Brightness
Adjust the values by pressing
/
on the projector or remote control.
The higher the value, the brighter the image. And lower the setting, darker the image.
Adjust this control so the black areas of the image appear just as black and that detail in
the dark areas is visible.
Adjust this control so the black areas of the image appear just as black and that detail in
the dark areas is visible.
Adjusting Contrast
Adjust the values by pressing
/
on the projector or remote control.
The higher the value, the greater the contrast. Use this to set the peak white level after
you have previously adjusted the Brightness setting to suit your selected input and
viewing environment.
you have previously adjusted the Brightness setting to suit your selected input and
viewing environment.
50
-30
+70
-30
50
+70