Sony PX35 Manual De Usuario

39

 GB

Maintenance

Main

ten

ance

Insert the new lamp all the way in until 
it is securely in place. Tighten the 
screws.  Fold up the handle. 

• Be careful not to touch the glass surface 

of the lamp.

• The power will not turn on if the lamp is 

not secured properly.

Close the lamp cover and tighten the 
screws.

• Do not tighten the screws too much.  

Doing so could damage some of the 
internal components of the projector.

Turn the projector back over.

Connect the power cord and turn the 
projector to standby mode.

Press the following keys on the 
control panel in the following 
sequence for less than five seconds 
each: RESET, 

<, ,, ENTER.

• Do not put your hands into the lamp 

replacement spot, or not fall any liquid or 
object into it to avoid electrical shock or 
fire. 

• Be sure to use the LMP-P260 Projector 

Lamp for replacement. If you use lamps 
other than LMP-P260, the projector may 
cause a malfunction.

• Be sure to turn off the projector and unplug 

the power cord before replacing the lamp.

• We recommend that you also clean the air 

filter whenever you replace the lamp.

As the used lamp contains Mercury, dispose 
of the lamp according to local, state or 
federal laws.

As the materials used in this lamp are similar 
to those of a fluorescent lamp, you should 
dispose of a used projector lamp in the same 
way as a fluorescent lamp.

The air filter should be cleaned every 1500 
hours. 
Remove dust from the outside of the 
ventilation holes with a vacuum cleaner.

When it becomes difficult to remove the dust 
from the filter with a vacuum cleaner, 
remove the air filter and wash it.

Turn off the power and unplug the 
power cord.