Viewsonic PJ1172 Manual De Usuario

• Turn the power on/off in right order. Please power on the projector before the connected 

devices. Power off the projector after the connected devices.

Remove the lens cap.

Set the power switch to [ | ] (On).
The STANDBY/ON indicator will light to solid 
orange.

Press the STANDBY/ON button.
The projector lamp will light up and the STANDBY/
ON indicator will begin blinking green. When the 
power is completely on, the indicator will stop 
blinking and light green.

Select an input signal according to the section 
“Selecting An Input Signal” of the following page.

Press the STANDBY/ON button.
The message “Power off?” will appear on the 
screen for approximately 5 seconds.

Press the STANDBY/ON button again while 
“Power off?” message is visible.
The projector lamp will go off, and the STANDBY/
ON indicator will begin blinking orange. The 
STANBY/ON indicator will stop blinking and light to 
solid orange when the lamp cooling is complete.

Set the power switch to [O] (Off).
The STANDBY/ON indicator will go off.

Attach the lens cap.

 

• When the power is “On”, a strong light is emitted. Do not look into the lens or vents of 

the projector.

STANDBY/ON button / indicator

Power switch (On position)

STANDBY/ON 
button

Power switch (Off position)

STANDBY/ON 
button

STANDBY/ON button / indicator