Infocus XS1 Manual De Usuario
Operation
25
Setting a password
Once a password has been set and the power on lock is activated, the projector cannot be
used unless the correct password is entered every time the projector is started.
used unless the correct password is entered every time the projector is started.
Once a password has been set and the splash screen lock is activated, you cannot change the
splash screen that displays at projector startup unless the correct password is entered.
splash screen that displays at projector startup unless the correct password is entered.
1.
Open the OSD menu and go to the SYSTEM SETUP: Advanced > Security
Settings menu. Press Mode/Enter. The Security Settings page displays.
Settings menu. Press Mode/Enter. The Security Settings page displays.
2.
Highlight Change Security Settings and press Mode/Enter.
3.
As pictured to the right, the four arrow
buttons ( ,
buttons ( ,
, , ) respectively
represent 4 digits (1, 2, 3, 4). According to
the password you desire to set, press the
arrow buttons to enter six digits for the
password.
the password you desire to set, press the
arrow buttons to enter six digits for the
password.
4.
Confirm the new password by re-entering
the new password.
Once the password is set, the OSD menu
returns to the Security Settings page.
the new password.
Once the password is set, the OSD menu
returns to the Security Settings page.
5.
To activate the Power On Lock function, press / to highlight Power On
Lock and press /
Lock and press /
to select On.
6.
To activate the Splash Screen Lock function, press / to highlight Splash
Screen Lock and press /
Screen Lock and press /
to select On.
When the Splash Screen Lock is activated, the My Screen function in the
SYSTEM SETUP: Basic menu will be password-protected.
SYSTEM SETUP: Basic menu will be password-protected.
The digits being input will display as asterisks on-screen. Write your selected password down
here in this reference guide in advance or right after the password is entered so that it is
available to you should you ever forget it.
here in this reference guide in advance or right after the password is entered so that it is
available to you should you ever forget it.
Password: __ __ __ __ __ __
Keep this reference guide in a safe place.
7.
To leave the OSD menu, press Menu/Exit.
If you forget the password
If the password function is activated, you will be
asked to enter the six digit password every time
you turn on the projector. If you enter the wrong
password, the password error message as
pictured to the right displays lasting for three
seconds, and the INPUT PASSWORD message
follows. You can retry by entering another six-
digit password, or if you did not record the
password in this reference guide, and you
absolutely do not remember it, you can use the
password recall procedure. See
for
details.
If you enter an incorrect password 5 times in
succession, the projector will automatically shut
down in a short time.
INPUT NEW PASSWORD
Back
MENU
Power On Lock and Splash Screen Lock
use the same password
use the same password
Password Error
Please try again.