Infocus 210 Manual De Usuario

Use only a three-wire grounding type power source. The power 
source should not exceed 250 volts rms between the supply con-
ductors or between either conductor and the ground.

Use only the power cord that was shipped with the LitePro. 
Although other power cords might be similar in appearance, they 
have not been safety-tested with the 210 or 220. Do not use a 
power cord if it has become damaged or frayed. Contact your In 
Focus dealer or call In Focus if you need to replace your power 
cord.

The projector is grounded through the grounding conductor on 
the power cord. To avoid electric shock, plug the power cord into 
a properly wired receptacle. Do not defeat the purpose of the 
grounding-type plug.

described on page 43. If the lamp

For continued protection against the risk of fire, use only the 
specified fuse. It must be a time delay, high breaking capacity 
5x20mm fuse with the following amperages: for 6.3amp use 
T6.3AH, for 8amp use T8AH. Refer to page 55 for more informa-
tion about fuse specifications and to page 45 for instructions on 
replacing the fuse.

To avoid overheating and unacceptable image quality, replace 
the projection lamp with a lamp of the specified type. Refer to 
page 56 for lamp specifications and to page 43 for instructions on 
replacing the lamp.

To avoid burns or an explosion hazard, do not open the lamp 
module door until the projector is turned off and the lamp has 
cooled. The hot lamp contains high pressure and can explode if 
damaged or old. Follow the instructions in this manual for lamp 
replacement carefully.