Christie Digital Systems CSP70 Manual De Usuario
Section 2: Installation and Setup
2-2 RPMSP & CSP70-D100U User’s Manual
Connect the
SYNC
BNC input(s) first. Then connect the red, green and blue source
outputs to the
RED
,
GREEN
, and
BLUE
BNCs on the
INPUT 1
panel. If the source uses
sync-on-green, only the red, green, and blue connections are required. If the source
provides a composite sync output, connect it to the
provides a composite sync output, connect it to the
SYNC
input labeled
HOR/COMP
. If
the source provides separate horizontal and vertical sync outputs, connect horizontal
sync to the
sync to the
SYNC
input labeled
HOR/COMP
and connect vertical sync to
SYNC
input
labeled
VERT.
See Figure 2.2.
Figure 2.2. Connecting RGB and Sync
NOTES: 1) If for some reason the projector fails to recognize a signal as an RGB
signal, specify this Color Space option within the Image Settings menu. See 3.5
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
sources–to
signal, specify this Color Space option within the Image Settings menu. See 3.5
Adjusting the Image. 2) To connect YPbPr signals–such as from DVDs or analog HDTV
sources–to
INPUT 1
, use the red, green and blue BNCs as described in YPbPr Signals
(below).
Connect a YPbPr signal (component video) to
INPUT 1
or
INPUT 2
as shown in Figure
2.3.
NOTES: 1) If, for some reason, the projector fails to recognize a YPbPr signal,
specify this Color Space option within the Image Settings menu. See 3.5, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
specify this Color Space option within the Image Settings menu. See 3.5, Adjusting
the Image. 2) Do not connect digital component signals (known as YCbCr) to
INPUT
1
. Install an appropriate optional module in
INPUT 5
for this.
Figure 2.3. Connecting YPbPr sources
YPbPr
Signals
'
(COMPONENT
VIDEO)