Sony PAM-200 Manual De Usuario

PAM-200 

 

 

 

 

Page - 6 - 

Installation Manual 

1.  Mounting Surfaces  
 NOTE: Use a 1/4” drill bit to pre-drill the mounting holes 
 

 

before securing the wood screws (supplied). 

Wood studs: 

Where denoted with the letter ‘A’, mark these 

 

 

locations for wood stud installation. 

 NOTE:  Use a masonry bit to pre-drill the mounting holes in 
 

 

the concrete surface. 

surface: Where denoted with the letter ‘B’, mark 

 

 

these locations for concrete installation. 

2.  Use two (2) #14 x 2” wood screws (supplied) to attach the 
 

ceiling plate to the wooden ceiling stud. 

NOTE: For extra security, attach a third wood screw to the 
 

 

middle mounting point (A).

 

 

 

3.  Slowly raise the projector toward the upper assembly. Once 
 

the projector is close to the upper assembly, MagnaGuide 

 

Technology will pull the lower assembly into the upper 

 

assembly and the locking tab will engage. 

WARNING: 

THE MAGNETS ARE USED FOR GUIDING

 

 

 

THE UNIT ONLY! PLEASE MAKE SURE

 

 

 

THE TWO (2) M4 X 12MM SCREWS ARE

 

 

 

USED TO SECURE THE PROJECTOR. 

4.  Attach the two (2) M4 x 12mm security screws and 
 

washers that are located on each side of the locking tab. 

NOTE: Do not release your hold on the projector until the 
 

 

upper and lower assemblies are engaged and the 

 

 

locking tab is in place.

 

NOTE:  If you choose to use the center mounting point for
 

added security, detach the adjustable suspension neck

 

by removing the two (2) M6 x 12mm security screws,

 

drive the wood screw in place and reattach the 

 

adjustable suspension neck and security screws.

 

 

After the projector has been installed, the projector must then be 
adjusted. To adjust the projector: 
1.  Loosen the M5 set screw using the M5 Allen wrench (both 
 sides). 
2.  Adjust the projector to the correct position. Firmly grasp the
 

projector in both hands, and tilt either forward or 

 

backward to adjust the level. 

-OR- 
 

Firmly grasp the projector in both hands and rotate side to 

 

side for orientation adjustment. 

3.  Tighten the M5 set screw on both sides using the M5 Allen 
 wrench.

 

 

 

1.  To adjust the height of the PAM-200, hold the weight of the 
 

projector and loosen the two (2) M6 x 12mm security 

 screws. 
2.  Slide the adjustable suspension neck into the desired 
 position. 
3.  Retighten the two (2) M6 x 20mm security screws. 
 
NOTE: 

Do not release the projector until the M6 screws are 

 completely 

tight. 

 

M5 Set Screw 

M6 x 20mm 
Security Screws 

M4 x 12mm Security 
Screw and Star Washer 

M6 x 12mm 
Security Screw 

M5 Allen 
Wrench

Adjustable 
Suspension Neck