Toshiba 232 Manual De Usuario
82
2.HOW TO MAKE COPIES
3.Bypass Copying (Cont.)
2
Bypass copying on non-standard size paper
Non-standard size paper should be within the following ranges:
A (Length): 3.9" to 11.7", B (Width): 5.8" to 17"
A (Length): 3.9" to 11.7", B (Width): 5.8" to 17"
2
Place the original on the original glass.
1
Place some sheets of paper with their
copy side down on the bypass tray. Align
the side guides to the paper length while
holding A.
copy side down on the bypass tray. Align
the side guides to the paper length while
holding A.
• The message “Ready for bypass feeding” appears.
• Rear side of the side guides of the bypass tray has an indicator
• Rear side of the side guides of the bypass tray has an indicator
for paper height. The height of the sheets must not exceed this
indicator.
indicator.
• When you use more than one sheet, fan the sheets well before
setting them on the tray.
• Do not push the sheets into the entrance of the bypass feeder; it
may cause a paper jam.
When the paper size is larger, draw out the three-stage paper
holder. Raise B when you use LD or a larger size of paper.
holder. Raise B when you use LD or a larger size of paper.
A
B
A
B