Citizen CBM-270 Manual De Usuario

CBM-270 User’s Manual

                                                                         

                                CITIZEN

28

4444....8888

P

PP

Paaaappppeeeer 

r 

r 

r N

N

N

Neeeeaaaar 

r 

r 

r E

E

E

Ennnnd 

d 

d 

d F

FF

Fuuuunnnnccccttttiiiioooonnnn

If the paper is running out, the PNE sensor informs the host computer that the paper is
running out, by means of a signal output or the PAPER lamp on the panel.    The PAPER lamp
is illuminated unconditionally.
1. If the PNE sensor detects that the paper is running out, the PAPER lamp will be

illuminated.

2. If PNE is enabled, the parallel interface will output PE. (At initial setting)
3. Printing is allowed up to about 1.5 m. (Initial value)    After printing or feeding the paper by

a specified amount, the parallel interface will output BUSY and FAULT, and serial interface
will output DTR to stop printing, respectively.

  4. Replace the paper according to the procedure in "4.3 Inserting the Paper."
  5. After replacing the paper, cancel the BUSY (DTR), FAULT, and PE outputs.

(1) The following lists the outputs made by the near paper end function and the paper end

function.    The output state can be changed by the DIP switch or a command.

DS1-1

State

PNE

Function

PE Signal Output

Setting by Command

PE Output

BUSY (DTR)/

FAULT Output

PAPER

Lamp

*When PE is selected

*When PE is detected

*When PE is detected *At PNE

OFF

Disabled When PNE is selected When PNE is detected

When PE is detected

  At PNE

When PE is selected

When PE is detected

When  printing  stops

due to PNE

 At PNE

ON

Enabled

*When PNE is selected *When 

PNE 

is

detected

*When printing stops

due to PNE

*At PNE

*Mark : Default setting

 PNE : Paper Near End      PE : Paper End

(2) Print amount after detecting PNE

When PNE is enabled, a printable amount after PNE detection can be adjusted.    PNE is
detected when the remaining amount of the paper roll is about 2

~

3 m.  (It depends on the

paper quality used, paper thickness, and operating environment.)
An initial value is 1.5 m.    Up to 1.5 m can be printed after detecting PNE.    At this time,
with the approx. 70mm-thick recommended paper, the remaining amount of the paper will
be about 0.5

~

1.5 m when printing stops.

It can be adjusted between 0 and 2.55 m with a command.    Adjust it depending on the
operating environment and paper quality.
Depending on an adjustment value, paper end may be detected (Printing stop) first.
If PNE is detected at power-on, a set amount of printing will be done from that point.
(The default is 1.5 m)