Canon AXIS 1610 Manual De Usuario

Section 3

Installation

Connecting a printer to the Network

Follow the instructions below to connect a printer to the 

network via the AXIS 1610 print server.

❏ Make sure that the AXIS 1610 external power supply you are 

using is marked with the correct voltage!

1. Switch off the printer and disconnect the AXIS 1610 external 

power supply.

2. Locate the serial number, found on the underside label of the 

AXIS 1610, and write it down. You will need this number later 
during the network configuration.

3. Connect the AXIS 1610 directly to the printer’s parallel printer 

port.

4. Connect your AXIS 1610 to the network using a twisted pair 

cable, category 5 or better.

5. Switch on the printer and connect the external power supply to 

the AXIS 1610. The power indicator lights up. When the network 
indicator starts to flash, the AXIS 1610 is successfully connected 
to the network.

To establish communication with the TCP/IP network and the 

internal web pages, an IP address must be assigned to your AXIS 
1610. 

If there is a DHCP server on your network, your AXIS 1610 will 

already have received an IP address. 
If not, refer to the table below for an appropriate method to set 

the IP address of your AXIS 1610.