Citizen Systems PMU2XXX Manual De Usuario

- 311 -

If printing of “E” of 2 times vertical (48 dots) is
attempted there, 48 dots are not printed in the

remaining area of 36 dots. Therefore, “E” is

printed from next label’s first print position.

Here, line feed of “E” must also be included in the

calculation of the height of “E”. (See figure below.)

5.4 Cautions on Black Mark/Label Paper

Cautions on LF (CR), ESC J, ESC d, Page mode, Image, and barcode printing.
Printing of image greater than vertical print area of BM paper/label paper used is prohibited as a rule.
The user must use label while taking label size into account at all times and terminate printing of a sheet
of label with FF, ESC FF or GS FF.

AAAAAAAAAAAAAAAAAAA
BBBBBBBBBBBBBBBBB
CCCCCCCCCCCCCCCCC
DDDDDDDDDDDDDD

ＥＥＥＥＥＥＥＥＥＥ

After printing of “D” in the left figure, remainder of

vertical print area must be 36 dots.

AAAAAAAAAAAAAAAAAA

BBBBBBBBBBBBBBBB

CCCCCCCCCCCCCCCCC

Only character can be printed here but printed on

next label

EEEEEEEEEEEEEEEEEE

ドット

as feed amount cannot be applied.

As shown in the left figure, character height is 24

dots. If, however, line feed width is 60 dots by the

setting or command such as ESC 3 or the like,

vertical print area is calculated including line feed

width in character height. If printing in vertical

area is not available, printing is started from the

first print position of the next label.

The same principle applies to image and barcode.
Barcode and image are as shown on the next page.