Citizen Systems PMU2XXX Manual De Usuario

 

- 73 - 

GS  ＼ nL nH 

 

 

Specifying the relative vertical position of a character in PAGE MODE

 

 

[Code] 

<

1D>H<5C>H<nL><nH> 

 

[Range] 

0≦nL≦255、0≦nH≦255 

 

 

 

This command is used in PAGE MODE to specify the vertical position of a character in the data 
mapping start position, in a relative position with respect to the current position. The next data 
mapping start position will be at a point [(nL+nH×256)×basic calculation pitch] inches away from 
the current position.

 

 

 

• This command is ignored when PAGE MODE is not selected.

 

• If a new position is specified for a character located beneath the current position, it should be 

specified as positive (+). If it is above the current position, it should be negative (–).

 

• A negative value is the complement of 65536. For example, to move the position by N pitches up, 

specify it as: nL + nH x 256 = 65536 – N

 

• The specification of a relative position outside the specified print area is ignored.

   

• Depending on the start point specified by ESC T, this command acts as follows: 

(1) If the start point is the top left or bottom right, the command specifies the relative position in 

the paper feed direction (the character’s top-bottom direction) using the vertical basic 
calculation pitch (y). 

(2) If the start point is the top right or bottom left, the command specifies the relative position in 

the direction perpendicular to the paper feed (the character’s top-bottom direction) using the 
horizontal basic calculation pitch (x). 

• The basic calculation pitch is set by GS P.

 

• Fractions resulting from calculations are corrected with the minimum pitch of the mechanism, and 

the remainder is omitted.