Citizen Systems 500 Manual De Usuario
14
English
Press the LOAD/PARK key on the front panel to load
the paper in to the printer. The paper will stop at the
first line of printing, or “top of form”.
the paper in to the printer. The paper will stop at the
first line of printing, or “top of form”.
Insert the top cover again and raise it to the upright
position.
position.
This is done by inserting the side pins of the top
cover into the slots in the upper case.
cover into the slots in the upper case.
Slide the paper support upwards until it stops to provide
additional guidance and separation of the inbound and
outbound paper.
additional guidance and separation of the inbound and
outbound paper.
If the ON LINE indicator light is not lit, press the ON LINE
key to ensure the printer is ready to print.
key to ensure the printer is ready to print.
Fanfold Paper (Bottom Tractor Mode)
Turn the power off to the printer. Adjust the head gap lever for the thickness of paper that you are
using, then set the paper feed selector to the bottom tractor mode position.
using, then set the paper feed selector to the bottom tractor mode position.
While lifting up the printer on its back edge, pull out the
paper stand shafts (1) and lock them in the forward
position.
paper stand shafts (1) and lock them in the forward
position.
The pull tractors are
shown in (2)
shown in (2)
Unlock the pull tractors by pushing the tractor clamping le-
vers (1) upwards.
vers (1) upwards.
Slide the tractors (2) to approximate width of paper. The
plastic rib (3) moulded in to the lower case will give you an
indication of the left-most print position.
plastic rib (3) moulded in to the lower case will give you an
indication of the left-most print position.