Samsung CLP-660 Series Manual De Usuario

3.1   

<Getting Started>

This chapter gives you step-by-step instructions for setting up the 
machine.

This chapter includes:
•

This section shows the steps to set up the hardware which is explained 
in the Quick Install Guide. Make sure you read Quick Install Guide and 
complete following steps.

Select a stable location. 

Select a level, stable place with adequate space for air circulation. 
Allow extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 
sources of heat, cold, and humidity. Do not set the machine close to 
the edge of your desk or table. 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to 
the altitude setting to optimize your printing. See page 3.4 for more 
information.

Place the machine on a flat and stable surface, not letting it tilt more 
than 2 mm (0.08 inches). Otherwise, it may affect the print quality. 

Unpack the machine and check all the enclosed items.

Remove the tape holding the machine tightly.

Install all four of the toner cartridges.

Load paper. (See "Loading paper" on page 4.4.)

Make sure that all the cables are connected to the machine. 

Turn the machine on. 

When you move the machine, do not tilt or turn it upside 
down. Otherwise, the inside of the machine may be 
contaminated by toner, which can cause damage to the 
machine or bad print quality.

You need to set up the network protocols on the machine to use it as your 
network printer. You can set up the basic network settings with the 
machine’s control panel.

• If you want to use the USB cable, connect between a computer 

and your machine. Then, refer to the software installation in 
Software section.