Samsung ML-3051ND Manual De Usuario

.6   

<System setup>

This menu lets you configure the network interface installed in your 
printer. You can reset the network interface and print a configuration 
page.

This item allows you to manually set the TCP/IP 
addresses or receive the addresses from the 
network.
• DHCP: The DHCP server allots the IP address to 

you automatically.

• BOOTP: The BOOTP server allots the IP address 

to you automatically. 

• Static: You can enter IP address, subnet mask, 

and gateway manually. 

This item lets you select whether or not you use the 
EtherTalk protocol. Select On to use the protocol.

This item lets you select the IPX frame type.
• Auto: You can set the frame type automatically. 
• 802.2: Select this value to use the IEEE 802.2 

frame type. 

• 802.3: Select this value to use the IEEE 802.3 

frame type. 

• Ethernet II: Select this value to use the Ethernet 2 

frame type.

• SNAP: Select this value to use the SNAP frame 

type.

• Off: You can disable the NetWare protocol.

This item allows you to select the ethernet speed.

Configure the wireless network environments.
See page 10.3.

This menu only appears when an optional 
wireless network interface card has been 
installed. 

Values: DHCP, BOOTP, Static

Values: Off, On

Values: Auto, 802.2, 802.3, Ethernet II, SNAP, Off

Values: Auto, 10M Half, 10M Full, 

100M Half, 100M Full

Values: WLAN Basic, WLAN Security, WLAN Default

Print a demo page to make sure that the printer is operating correctly.

Press and hold Demo for about 2 seconds.

Press Menu and then OK when Information appears.

Press the Scroll buttons until Demo Page appears and press OK.

A demo page prints out.

(ML-3051N, ML-

 only)

To change the language that is displayed on the control panel, follow 
these steps:

Press Menu until System Setup appears on the bottom line of the 
display and press OK.

Press OK when Language appears.

Press the Scroll buttons to select the language you want and press 
OK

.

Press Stop to return to Standby mode.

This item performs a simple reset and restores the 
factory default settings for the network 
configuration. This setting will only take effect after 
you have reset the printer.

This item print a page showing the network 
parameters you set.