Samsung ML-3051ND Manual De Usuario

.2   

<Network setup>

To enter a TCP/IP address from your printer’s control panel, take the 
following step: 

Press Menu until Network appears on the bottom line of the 
display and press OK.

Press OK when TCP/IP appears.

Press the Scroll buttons until Static appears and press OK.

Press OK when IP Address appears. 

Set the first byte between 0 and 255 using the Scroll buttons and 
press OK to move to the next byte.

Repeat this to complete the address from the 1st byte to the 4th 
byte.

When you have finished, press OK.

Repeat step 5 and 6 to configure the other TCP/IP parameters: 
subnet mask and gateway address.

Press Stop to return to Standby mode.

To have a TCP/IP address assigned automatically by the server, take the 
following step:

Press Menu until Network appears on the bottom line of the 
display. 

Press OK when TCP/IP appears.

Press the Scroll buttons until DHCP or BOOTP appears and press 
OK

.

Press Stop to return to Standby mode.

EtherTalk is AppleTalk used in an Ethernet network. This protocol is 
widely used in Macintosh network environments. To use EtherTalk, take 
the following step:

Press Menu until Network appears on the bottom line of the 
display and press OK.

Press the Scroll buttons until EtherTalk appears and press OK.

Press the Scroll buttons until On appears and press OK.

Press Stop to return to Standby mode.

To use IPX/SPX protocol networks (for example, Novell NetWare), the 
format of the network communication frames must be specified for the 
printer. In most cases, you can keep the Auto setting. However, you can 
manually set the frame type format, if required. Take the following step 
to change the frame type format:

Press Menu until Network on the bottom line of the display and 
press OK. 

Press the Scroll buttons until NetWare appears and press OK.

Press the Scroll buttons until the desired frame type appears.
• Auto: Automatically senses and limits the frame type to the first 

one detected.

• 802.2: Limits the frame type to IPX over IEEE 802.2 with IEEE 

802.3 frames. All others will be discarded.

• 802.3: Limits the frame type to IPX over IEEE 802.3 frames. All 

others will be discarded.

• Ethernet II: Limits the frame type to IPX over Ethernet Frames. All 

others will be discarded.

• SNAP: Limits the frame type to IPX over SNAP with IEEE 802.3 

frames. All others will be discarded.

• Off: The IPX/SPX protocol is disabled.

Press OK to save the selection.

Press Stop to return to Standby mode.