Samsung CLP775ND Manual De Usuario

Media and tray_ 45

For example, if you want to use a label, set the paper type 

to Label.

d)

Select MP Tray in paper source, then press OK.

e)

Start printing in application.

f)

After printing, close the multi-purpose tray.

The table below shows the available special media for each tray. 

When using special media, we recommend you feed one paper at a 

time. Check the maximum input number of media for each tray. (See 

"Print media specifications" on page 92.)

( ●: Included, Blank: Not available) 

Successful printing on envelopes depends upon the quality of the 

envelopes. 
To print an envelope, place it flap side up with the stamp area bottom the 

top right side.

•

When selecting envelopes, consider the following factors:

-

Weight:  The weight of the envelope paper should not exceed 

90 g/m

2

 otherwise, jam may occur.

-

Construction:  Prior to printing, envelopes should lie flat with less 

than 6 mm curl, and should not contain air.

-

Condition:  Envelopes should not be wrinkled, nicked, nor 

damaged.

-

Temperature:  Use envelopes that are compatible with the heat and 

pressure of the machine during operation.

•

Use only well-constructed envelopes with sharp-and well-creased folds.

•

Do not use stamped envelopes.

•

Do not use envelopes with clasps, snaps, windows, coated lining, 

self-adhesive seals, or other synthetic materials.

•

Do not use damaged or poorly made envelopes.

•

Be sure the seam at both ends of the envelope extends all the way to 

the corner of the envelope.

•

Envelopes with a peel-off adhesive strip or with more than one flap that 

folds over to seal must use adhesives compatible with the machine’s 

fusing temperature for 0.1 second. To view the fusing temperature, 

check your machine’s specification. (See "General specifications" on 

page 91.) The extra flaps and strips might cause wrinkling, creasing, or 

jams, and may even damage the fuser.

•

For the best print quality, position margins no closer than 15 mm from 

the edges of the envelope.

•

Avoid printing over the area where the envelope’s seams meet.

To avoid damaging the machine, use only transparencies designed for use 

in laser printers.

In case of color printing using transparencies, the picture quality would 

be lower than mono printing when the printouts are used on the 

overhead projector.

•

Transparencies used in the machine must be able to withstand 

machine’s fusing temperature.

•

Place them on a flat surface after removing them from the machine.

•

Do not leave unused transparencies in the paper tray for long periods of 

time. Dust and dirt may accumulate on them, resulting in spotty printing.

•

To avoid smudging caused by fingerprints, handle them carefully.

•

To avoid fading, do not expose printed transparencies to prolonged 

sunlight.

•

Ensure that transparencies are not wrinkled, curled, or have any torn 

edges.

•

Do not use transparencies that separates from the backing sheet.

●

●

●

●

●

●

●

●

●

●

●

●

Thin 

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●

●