Samsung CLP775ND Manual De Usuario

Supplies and accessories_ 87

When installing accessories, the battery inside the machine is a 

service component. Do not change it by yourself.
There is a risk of an explosion if battery is replaced by an incorrect 

type. Dispose used batteries according to the instructions.

After installing added accessories, you need to select it in the printer 

properties of the printer driver in order to use it.
1. Install the driver. (See "Installing the driver locally" on page 23 or 

2. For Windows 2000, select Settings > Printers.

•

For Windows XP/2003, select Printers and Faxes. 

•

For Windows 2008/Vista, select Control Panel > Hardware and 

Sound > Printers. 

•

For Windows 7, select Control Panel > Hardware and Sound > 

Devices and Printers. 

•

For Windows Server 2008 R2, select Control Panel > Hardware > 

Devices and Printers. 

3. For Windows 2000, XP, 2003, 2008 and Vista, double-click your 

machine.
For Windows 7 and Windows Server 2008 R2, right click your printer 

icon > context menus > See what’ s printing.

4. Select the your machine’s driver and right-click to open Properties. 
5. In printer driver properties, select Device Options. 
6. In printer driver properties, set the necessary options.
7. Click OK. 

Your machine has a dual in-line memory module (DIMM). Use this memory 

module slot to install additional memory. (See "Available accessories" on 

page 83.)

1. Turn the machine off and unplug all cables from the machine.
2. Open the control board cover. Release the screw, then lift up the cover 

slightly and pull the cover to the right.

3. Take out a new memory module from its plastic bag.

4. Holding the memory module by the edges, align the memory module on 

the slot at about a 30-degree tilt. Make sure that the notches of the 

module and the grooves on the slot fit each other.

The notches and grooves illustrated above may not match those 

on an actual memory module and its slot.

5. Press the memory module into the slot with care until you hear a 'click'. 

Do not press the memory module strongly or the module may be 

damaged. If the module does not seem to fit into the slot properly, 

carefully try the previous procedure again.

6. Replace the control board cover and fasten the cover with the screw.

7. Reconnect the power cord and machine cable. Turn on the machine.

The machine is equipped with a network interface which allows you to use 

your printer on a network. You can also purchase a wireless network 

interface card to enable the use of the printer in wireless network 

environments.
The order information is provided for optional wireless network interface 

card. (See "Available accessories" on page 83.)

1. Turn the machine off and unplug all cables from the machine.
2. Open the control board cover. Release the screw, then lift up the cover 

slightly and pull the cover to the right.