Samsung SCX-5935 Series Manual De Usuario

Supplies and accessories_ 125

To purchase maintenance parts, contact the source where you bought the 

machine. 
Replacing maintenance parts can be performed only by an authorized 

service provider, dealer, or the retailer where you bought the machine. The 

warranty does not cover the replacement of any maintenance parts after 

their lifespan.

When the toner cartridge is completely empty:

•

Toner cartridge is worn. Replace with new one appears on the 

display. 

•

The machine stops printing. Incoming faxes are saved in memory. 

At this stage, the toner cartridge needs to be replaced. Check the type of the 

toner cartridge for your machine. (See "Available supplies" on page 124.)
1. Open the front cover.
2. Pull the toner cartridge out.

3. Remove the new toner cartridge from its bag. 
4. Slowly shake the cartridge five or six times to distribute the toner evenly 

inside the cartridge. It will assure maximum copies per cartridge. 

If toner gets on your clothing, wipe it off with a dry cloth and wash 

clothing in cold water. Hot water sets toner into fabric.

Do not touch the green underside of the toner cartridge. Use the 

handle on the cartridge to avoid touching this area. 

5. Hold the toner cartridge by the handle and slowly insert the cartridge into 

the opening in the machine. 
Tabs on the sides of the cartridge and corresponding grooves within the 

machine will guide the cartridge into the correct position until it locks into 

place completely.

6. Close the front cover. Make sure that the cover is securely closed. 

•

Disconnect the power cord.

Never remove the control board cover while the power is turned on.

To avoid the possibility of an electrical shock, always disconnect the 

power cord when installing or removing ANY internal or external 

accessories.

•

Discharge static electricity.

The control board and internal accessories (network interface card or 

memory module) are sensitive to static electricity. Before installing or 

removing any internal accessories, discharge static electricity from your 

body by touching something metal, such as the metal back plate on any 

device plugged into a grounded power source. If you walk around before 

finishing the installation, repeat this procedure to discharge any static 

electricity again.

•

Activating the added accessories in the PS driver properties.

After installing an accessory such as an optional tray, PS driver users 

must do the additional setting. Go to the PS printer properties and set 

the added accesorry activated. 

When installing accessories, the battery inside the machine is a 

service component. Do not change it by yourself.
There is a risk of an explosion if battery is replaced by an incorrect 

type. Dispose used batteries according to the instructions.

Your machine has a dual in-line memory module (DIMM). Use this memory 

module slot to install additional memory.
The machine has two memory slots with a factory pre-installed memory 

module in one slot. When you are expanding the memory capacity, you can 

add a memory module to the vacant memory slot. It is strongly 

recommended that you expand a memory module in the vacant memory 

slot, and not by removing a pre-installed memory module. If your machine 

Approx. 100,000 pages

RPR-PAD 

CASSETTE

Approx. 150,000 pages

ROLLER-PICK UP

a.It will be affected by operating system used, computing performance, 

application software, connecting method, media type, media size and 

job complexity.