Samsung SRP-350PLUSA&C Manual De Usuario
Rev. 1.02
- 13 -
SRP-350plusA&C
1-5 Setting the Memory Switches
This printer has “Memory Switch” set which is software switches. Memory Switch set has
“MSW1”, “MSW2”, “MSW8”, “MSW9” “Customize value”, “Serial communication condition”.
“Memory Switch setting utility” can change the Memory Switch set to ON or OFF as shown
in the table below. (default : all OFF)
“MSW1”, “MSW2”, “MSW8”, “MSW9” “Customize value”, “Serial communication condition”.
“Memory Switch setting utility” can change the Memory Switch set to ON or OFF as shown
in the table below. (default : all OFF)
NOTE
The Memory Switch is available to be changed by three methods.
- Memory Switch setting utility.
- Control from ESC/POS command.
The Memory Switch is available to be changed by three methods.
- Memory Switch setting utility.
- Control from ESC/POS command.
Settings of the Memory Switch are stored in the NV memory : therefore, even if the printer
is turned off, the settings are maintained.
is turned off, the settings are maintained.
MSW1
Switch
Function
ON
OFF
1~8
Reserved
--
Fixed to OFF
MSW2
Switch
Function
ON
OFF
1
Font Selection
Font B (9 x 24)
Font A (12 x 24)
2
Auto Cutter Function
Full Cutting
Partial Cutting
3~8
Code Page Selection
Refer to following Table