Samsung ML-371X Manual De Usuario

Descargar
Página de 245
Regulatory information
96
5. Appendix
This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. 
If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from 
that to which the receiver is connected.
Consult the dealer or experienced radio TV technician for help.
 
Change or modifications not expressly approved by the 
manufacturer responsible for compliance could void the 
user's authority to operate the equipment.
 
Canadian radio interference regulations
This digital apparatus does not exceed the Class B limits for radio 
noise emissions from digital apparatus as set out in the interference-
causing equipment standard entitled “Digital Apparatus”, ICES-003 
of the Industry and Science Canada.
Cet appareil numérique respecte les limites de bruits 
radioélectriques applicables aux appareils numériques de Classe B 
prescrites dans la norme sur le matériel brouilleur: “Appareils 
Numériques”, ICES-003 édictée par l’Industrie et Sciences Canada.
13 
United states of america
Federal communications commission (FCC)
► Intentional emitter per FCC Part 15
Low power, Radio LAN type devices (radio frequency (RF) wireless 
communication devices), operating in the 2.4 GHz/5 GHz Band, may 
be present (embedded) in your printer system. This section is only 
applicable if these devices are present. Refer to the system label to 
verify the presence of wireless devices.
Wireless devices that may be in your system are only qualified for use 
in the United States of America if an FCC ID number is on the system 
label.