Samsung CLP-315N Manual De Usuario

Getting started

getting started

This chapter gives you step-by-step instructions for setting up the machine.

•

•

•

•

•

•

•

•

This section shows the steps to set up the hardware which is explained in 

the Quick Install Guide. Make sure you read Quick Install Guide and 

complete following steps.
1.

Select a stable location. 
Select a level, stable place with adequate space for air circulation. Allow 

extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 

sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the 

altitude setting to optimize your printing. See "Altitude adjustment" on 

page 30 for more information.

Place the machine on a flat and stable surface, not letting it lean more 

than 2 mm (0.08 inches). Otherwise, it may affect the printing quality. 

Unpack the machine and check all the enclosed items.

Remove the tape holding the machine tightly.

Load paper. (See "Changing the size of the paper in the paper tray" on 

Make sure that all the cables are connected to the machine. 

Turn the machine on. 

Print a demo page to make sure that the machine is operating correctly.

To print a demo page:
In ready mode, press and hold the 

 button for about 2 seconds.

When you move the machine, do not tilt or turn it upside down. 

Otherwise, the inside of the machine may be contaminated by toner, 

which can cause damage to the machine or bad print quality.

This equipment will be inoperable when mains power fails.