Samsung ML-3712ND/XAA Manual De Usuario

There are two methods available to connect your machine to a 
wireless network using the 

 (WPS) button on the control panel.

The Push Button Configuration (PBC) method allows you to 
connect your machine to a wireless network by pressing both the 

 

(WPS) button on the control panel of your machine and the WPS 
(PBC) button on a Wi-Fi Protected Setup™ (WPS)-enabled access 
point (or wireless router) respectively.

The Personal Identification Number (PIN) method helps you 
connect your machine to a wireless network by entering the 
supplied PIN information on a Wi-Fi Protected Setup™ (WPS)-
enabled access point (or wireless router).

Factory default in your machine is PBC mode, which is 
recommended for a typical wireless network environment.

 

To change the WPS mode , press 

 (Menu) > Network > 

Wireless > OK > WPS Setting.

 

Press and hold the 

 (WPS) button on the control panel for 

more than 2 seconds.

The machine starts waiting for up to two minutes until you 
press the WPS (PBC) button on the access point (or wireless 
router).

Press the WPS (PBC) button on the access point (or wireless 
router).

The messages are displayed on the display screen in the order 
below:

The machine is connecting to the access 

point (or wireless router).

When the machine is successfully connected 

to the wireless network, the WPS LED light stays on.

After completing the wireless network 

connection process, the AP’s SSID information appears on 
the display.