Printronix PSA3 Manual De Usuario
58
Chapter
3
Configuring The KSSM Emulation With Control Codes
Select Condensed Printing
ASCII Code ESC SI
Hex Code
1B 0F
Dec Code 27
15
Purpose
Enters condensed mode, in which character width is reduced
as follows:
as follows:
Comment
This command is ignored under the following two conditions:
15-cpi printing has been selected with the ESC g command.
15-cpi printing has been selected with the ESC g command.
This command reduces character width by about 50% when
proportional spacing is selected with the ESC p command.
proportional spacing is selected with the ESC p command.
Cancel condensed printing with the DC2 command.
If the front panel setting of “20 CPI Condensed” is Disable,
12-cpi printing will ignore the Condense command.
12-cpi printing will ignore the Condense command.
The default is Non-condensed printing.
Cancel Condensed Printing
ASCII Code DC2
Hex Code
12
Dec Code 18
Purpose
Cancels condensed printing selected by the SI or ESC SI
commands.
commands.
Comment
The default is Normal (non-condensed) printing.
Selected pitch
Condensed pitch
10 cpi
17.14 cpi
12 cpi
20 cpi
Proportional
½ width