Printronix P7000 Manual De Usuario
Chapter 6
Reprogramming The Security Key
308
Figure 25. Inserting The SPX into the Debug Port
4.
Power on the printer. The printer will begin its boot-up sequence.
5.
When the printer detects a valid SPX, the control panel displays:
“NEW SPX DETECTED
PRESS ENTER”
“NEW SPX DETECTED
PRESS ENTER”
NOTE: If an error message displays, find the message in the Message
List in Chapter 7 and follow the troubleshooting instructions.
6.
Press the ENTER key to activate the reprogramming sequence.
The display will read:
“PROGRAMMING. PLEASE WAIT.”
The display will read:
“PROGRAMMING. PLEASE WAIT.”
7.
When the security key is reprogrammed, the display will read:
“REMOVE USED SPX
THEN PRESS ENTER”
“REMOVE USED SPX
THEN PRESS ENTER”
8.
Remove the SPX from the debug port at the rear of the printer.
A
A
Debug Port
SPX