Primera Technology LX810 Manual De Usuario

Max

Min

Label width

8.25" (210mm)

0.75" (19mm)

Liner width

8.375" (212mm) 1.5" (38mm)

Label height/length

24" (609.6mm) 

0.75" (19mm)

Gap between labels

10" (253mm)

0.10 (2.5mm)

Width of thru-hole 

0.5" (12.65mm)

0.25" (6.325mm)

opening
Distance from edge of 

2.25" (57mm)

0.20" (5.06mm)

media to edge of 

thru-hole
Reflective/Black 

N/A 

0.1" (2.54mm)  

Mark Width*
Max Outer Diameter (OD) 6.0"(152.4mm) 

N/A 

Inner Core Diameter (ID) 3.0" (76.2mm)

3.0" (76.2mm)  

Total Thickness 

.0075” 

N/A 

(Liner + Label)**

(7.5 mil)

Distance from edge of 

Printer driver assumes 2 mm gap. 

media to edge of label

However, this is adjustable via the 

left margin offset. 

* The Reflective/Black Mark should be opaque to infared light. The

mark should be between the labels. The end of the mark should corre-

spond with the beginning of the label. 
**There are two factors that determine whether the printer will accept

any particular stock thickness. 
1.  The ability for the printer to pull the paper through the print

area. 

2.  The ability for the sensor to read through the backing if the sen-

sor is set to die cut. 

If you are printing in continuous or reflective label sensing mode

number 2 does not apply.  The fact that the printer must read through

the backing in die-cut mode will limit the thickness much more than

the printers ability to pull the paper through the print area. However,

if you adjust opacity level of the liner enough to allow the label to be

seen by the stock sensor, the thickness will only be limited by the

printers ability to pull it through the printer area.  For these reasons

the weight or thickness of the liner is a variable that can not easily be

defined. Primera recommends and uses 40# liner with all label stock.

510943.qxd  11/27/2007  11:27 AM  Page 44