Paxar Monarch 9825 Manual De Usuario

11 

Description/Action 

Name must be 1 to 8 characters inside quotes. 

Supply width is invalid. 

Code page selection defined in the field is invalid. 

Data length is too long. 

Format referenced by batch not in memory. 

Invalid character following {. 

Field separator was not found. 

Printer memory is full.  Delete unnecessary formats or graphics from memory. 

Parity mismatch. 

Framing error (baud rate mismatch). 

Flow control mismatch. 

Online receive buffer is full.  Check for a flow control problem.  

Font, bar code, or density in the batch does not fit the format. 

The data in this line of the batch is either missing or does not match the format. 

Reference point off supply. 

Portion of field off supply or there may be an invalid character in the packet. 

The printer sensed a calibration of different-sized black marks.  Make sure the 
correct supply type is loaded. 

Printer has not sensed a supply mark when expected or is out of supplies.  
Press Escape/Clear and try to continue printing.  Change supply. 

Printer did not sense a black mark when expected.  Press Escape/Clear and try 
to continue printing.  Change supply. 

Printer sensed a mark in the wrong place. 

Printer sensed a mark that is too long. 

Check for a ribbon jam or remove any slack in the ribbon by turning the take-up 
reel clockwise.  Load a new ribbon. 

Printhead is open.  Close the printhead. 

Load supplies. 

Load supplies (supply length mismatch).  Press Feed/Cut. 

Either the supply is not seen, the on-demand sensor is broken, or a label was 
removed too quickly.  Check for a label jam or reload supplies. 

Waiting to dispense label.  Press Feed/Cut. 

The printhead has less than 8 bad dots and can shift bar code fields to avoid 
bad dots.  Press Escape/Clear to continue printing.   

Printhead has more than 30 bad dots or is not connected.  Connect the 
printhead.