KYOCERA 2020D Manual De Usuario

Maintenance

5-3

The printer displays messages at two stages of toner usage. This 
message is automatically alternated with the other printer message 
(such as 

Ready):

When the printer becomes low on toner, the printer displays the 
message 

Toner low as the first caution. Note the replacement is 

not always necessary at this stage.

If you ignore the above message and continue printing, the printer 
displays the message 

Replace toner - just before the toner is 

used up. The toner container must be replaced immediately. After 
the cleaning is finished, however, the message does not 
automatically change to 

Ready. To restart printing, you must press 

[GO] and make the printer ready.

In either case, replace the toner container, refer to Replacing the Toner 
Container on page 1-3.

This section explains how to replace the toner container. When replacing 
the toner container, always replace the waste toner box at the same 
time. If this box is full, the printer may be damaged or contaminated by 
the waste toner that may spill over the box.

1

Open the top cover.

Do not attempt to incinerate the Toner 

Container. Dangerous sparks may cause burns.

During toner container replacement, temporarily move 

storage media and computer supplies (such as floppy disks) away 
from the toner container. This is to avoid damaging media by the 
magnetism of toner.

Kyocera Mita Corporation is not liable against any 

damages or problems arising from the use of toner containers other than 
those designated as original Kyocera toner containers. For optimum 
performance, it is also recommended to use only the Kyocera toner 
containers which are specifically intended for use in your country or 
region. If the toner container for another destinations is installed, the 
printer will stop printing.

You do not have to turn printer power off before starting 

the replacement. Any data that may be processing in the printer 
will be deleted if you turn the printer power off

.